↓ Skip to main content

Transpulmonary and pleural pressure in a respiratory system model with an elastic recoiling lung and an expanding chest wall

Overview of attention for article published in Intensive Care Medicine Experimental, September 2016
Altmetric Badge

Citations

dimensions_citation
12 Dimensions

Readers on

mendeley
33 Mendeley
Title
Transpulmonary and pleural pressure in a respiratory system model with an elastic recoiling lung and an expanding chest wall
Published in
Intensive Care Medicine Experimental, September 2016
DOI 10.1186/s40635-016-0103-4
Pubmed ID
Authors

Per Persson, Stefan Lundin, Ola Stenqvist

Abstract

We have shown in acute lung injury patients that lung elastance can be determined by a positive end-expiratory pressure (PEEP) step procedure and proposed that this is explained by the spring-out force of the rib cage off-loading the chest wall from the lung at end-expiration. The aim of this study was to investigate the effect of the expanding chest wall on pleural pressure during PEEP inflation by building a model with an elastic recoiling lung and an expanding chest wall complex. Test lungs with a compliance of 19, 38, or 57 ml/cmH2O were placed in a box connected to a plastic container, 3/4 filled with water, connected to a water sack of 10 l, representing the abdomen. The space above the water surface and in the lung box constituted the pleural space. The contra-directional forces of the recoiling lung and the expanding chest wall were obtained by evacuating the pleural space to a negative pressure of 5 cmH2O. Chest wall elastance was increased by strapping the plastic container. Pressure was measured in the airway and pleura. Changes in end-expiratory lung volume (ΔEELV), during PEEP steps of 4, 8, and 12 cmH2O, were determined in the isolated lung, where airway equals transpulmonary pressure and in the complete model as the cumulative inspiratory-expiratory tidal volume difference. Transpulmonary pressure was calculated as airway minus pleural pressure. Lung pressure/volume curves of an isolated lung coincided with lung P/V curves in the complete model irrespective of chest wall stiffness. ΔEELV was equal to the size of the PEEP step divided by lung elastance (EL), ΔEELV = ΔPEEP/EL. The end-expiratory "pleural" pressure did not increase after PEEP inflation, and consequently, transpulmonary pressure increased as much as PEEP was increased. The rib cage spring-out force causes off-loading of the chest wall from the lung and maintains a negative end-expiratory "pleural" pressure after PEEP inflation. The behavior of the respiratory system model confirms that lung elastance can be determined by a simple PEEP step without using esophageal pressure measurements.

Mendeley readers

Mendeley readers

The data shown below were compiled from readership statistics for 33 Mendeley readers of this research output. Click here to see the associated Mendeley record.

Geographical breakdown

Country Count As %
Unknown 33 100%

Demographic breakdown

Readers by professional status Count As %
Other 5 15%
Student > Bachelor 5 15%
Researcher 4 12%
Student > Doctoral Student 2 6%
Student > Postgraduate 2 6%
Other 6 18%
Unknown 9 27%
Readers by discipline Count As %
Medicine and Dentistry 17 52%
Engineering 4 12%
Immunology and Microbiology 1 3%
Nursing and Health Professions 1 3%
Unknown 10 30%